CISS Systems Technology Solutions
Continuous Ink Supply System (CISS systems for short below) in its original printing supplies only one twentieth of the cost advantages, but attracted a lot of Penda the user's attention and use. However, for the first time understand that the purchase or use the connection for the system users, and even for the system related to what is a sponge, no sponge, what is the name of a permanent chip and related technologies are often not quite clear and understood. Here, the paper-related name for the system's technical explanations, so that we can better understand the connection for the system.
1, there is no difference between sponge
Produced using sponge cartridges in general are mostly original or compatible ink cartridge (even for only a small part of the sponge product design), these cartridges in the sponge to absorb and store to play the role of ink in order to avoid the ink in the atmospheric pressure on the nozzle pressure, led to the ink from the nozzle flow down to form Loumo, so the cartridges are usually the corresponding vent, the vent should meet certain size and indirect ventilation. If on the theory that there are sponge cartridges with ink from the nozzle in the ink-jet effect should be better than those without sponge, so print quality will be better. However, due to a corrosive chemical properties of ink, the ink sponge will be a gradual erosion, so that the ability to sponge ink absorption weakening caused by drops of ink, etc. and, therefore, can not be long-term use of these cartridges, which do not fit even for the system as a cartridges.
No sponge cartridges not only can solve the long-term use of traditional ink sponge, it will produce aging, gas block, break, return and other undesirable phenomena, and because less sponge inside the cartridge parts, so the ink cartridge storage capacity is also greater are the traditional sponge cartridges for each color is only about 11 milliliters, which may tend to use less than 9 ml, with no sponge cartridge is more than double its capacity to 2. In general, non-sponge ink cartridge can be recycled increases the use of, while the ink sponge plus 2 or 3 times not be able to add ink. No sponge cartridges can be long-term use, as well as a larger storage capacity of the ink, these features are suitable even for the system, so now most of the company for the system are based on non-sponge cartridge produced.
In addition, the tips a little, no sponge cartridges generally do not vent, ink, parked in a sealed tin bag, using a certain ink balance principle (that is, the so-called "no-sponge with constant pressure for the system"), and accompanied by a high density filter, not only so that the normal print cartridge, you can also print cartridge so that longer life expectancy.
What is permanent chip
EPSON printer cartridges usually are equipped with intelligent IC chip used to record ink usage, when the printer shows ink to do, the cartridge will stop working, to make ink cartridges back to work should be restored to the original IC Smart Chip state, the system applies even cartridges for frequent repeated use is necessary, therefore, be used even for the system EPSON cartridges will need to recover the IC smart chip or crack. The current recovery, crack EPSON intelligent cartridge IC chip approach, there are three: One is to use the recovery software, such as the use of Russia's SSC Service Utility software, the ink will run out of chips the state back to the initial state; the second is to Remove the cartridge from the printer with a decoder refresh, the same chip, the ink is run out of the state back to the initial state.
Both methods are rather troublesome because the software does not support all printers, and the recovery effects are far from satisfactory, remove the cartridge you need to refresh each time to refresh, the operation tedious, not to mention also decoder to help, so the two kinds of methods are not ideal, but even for the ink applied to adopt another approach often - directly loaded onto a permanent chip.
The size of the permanent chip on the size and the original cartridge smart chip is almost the same IC, which allows the state of ink from the ink runs out, automatically return to the initial state, or directly after each reboot, so that chip to monitor the "full ink "state, which makes ink cartridges can be used permanently. Thus, using different permanent chip, in the recovery methods are different. For example, in a permanent chip into the printer panel lights flashing, or the computer prompts "ink to make", the others are off the printer using the power again after a few minutes to open the power of the method; others are used to install the ink cartridges out of the "formalism "approach; either unplug the printer power plug, with the power to restore the way for a permanent chip. In short, using different permanent chip, its recovery methods will be different, but ultimately are designed to replace the original smart IC chip to allow cartridges to long-term use.
Third, even for the purchase and installation considerations
We know that even for the system is composed of a cartridge (ink sac), pipelines, stand, wear segment, permanent chip, ink, external box (bottles) and other components of the. Among these components, ink cartridges and permanent technical than chips higher, while the other components although there is no technical content, but they are in the purchase and installation, but many need attention. For example, the pipelines have been used normal hose and high-grade silicone tube are two types of high-grade silicone catheter can be avoided with the use of ink, the production of chemical reactions, there sediment; ink, you should use reliable quality, and not to use brand-name ink products, but there are many Even for the use of the system failure occurs, is caused due to the poor quality ink.
In addition, even for the system installation, they need special attention to adjust the height of outer cartridge to determine the direction and conduct of calandria bracket installation. Among them, adjust the height outside the cartridge can not even supply cartridge (with cartridges) inside the pressure balance, so that when the printing is unlikely that Loumo or not ink such a situation arises (for example, a level lower than that outside the cartridge nozzle position, nozzle so ink will show a negative pressure within the state, if the nozzle body negative pressure is greater than the power provided to the ink, then even the nozzle during printing movement, the ink can not be emitted from the nozzle, and vice versa) . And correctly set the direction and row of pipe mounting bracket, in addition to guarantee the normal operation of the printer ink car and outside the normal ink cartridges for ink, it can also play a role in improving the appearance of the printer. Of course, we went shopping for a mortgage system should choose products with easy installation features, so whether it is even available for the installation of the system itself, or increase after the ink inside the cartridge installation and removal of such operations can be more simple and convenient.
